Titan·Low voice. Clean consonants.
Titan is better on a grave subject, where the explainer should carry weight with a heavier, steadier read.
First choice for explainers and education
Anything that takes time to understand is where Heisenberg comes in as a first-choice explainer voice. The read is even and leaves room between ideas, so a viewer can follow a chain of cause and effect without rewinding.
The script below, generated with Heisenberg on Eleven v4 (1:03)
Original saved sample
Some explainers are a list of facts. Others are a chain, where each step only makes sense if the one before it landed. Heisenberg is built for chains.
It reads at about 175 words a minute in my clips, yet it gives every sentence a full stop's worth of silence, and the low, polished tone keeps the calm from tipping into sleepy. The viewer has time to picture the hexagon or the molecule before the next idea turns up. I'd pick it for science, maths and economics, for online course modules, and for any video essay over ten minutes where the audience has chosen to sit down and learn.
Its rate sits close to my average, about 175 words a minute, so a ten-minute video holds roughly 1,750 words. My quickest voices fit closer to 1,900 into the same ten minutes, and a script written for one of them will run a little long here. Trim it before you generate.
It also needs a script with some shape. A flat list of facts read this evenly starts to drag, and fast. Build each section around a question and its answer. For explainers under two minutes, go to Jett.
Yes, and course modules are where the pace pays off most, because learners are taking notes and following diagrams. Write one concept per paragraph and it will sound organized. My other long-form picks are on the narrator voices page.
It's 182 words, and my Eleven v4 render runs about 63 seconds. At Jett's measured 180 words a minute the same words would take about 61, so the two voices differ more in tone than in time.